ZyXEL Communications P-793H ユーザーズマニュアル
Chapter 3 Wizards
P-793H User’s Guide
54
3.1 Internet Setup Wizard
Use these screens to configure Internet access settings. To access this wizard, click
INTERNET SETUP in the wizard main screen.
INTERNET SETUP in the wizard main screen.
3.1.1 Screen 1
This screen lets you enter some of the ISP settings for your Internet connection.
Figure 12 Internet Access Wizard Setup: ISP Parameters
The following table describes the fields in this screen.
Table 6 Internet Setup Wizard: ISP Parameters
LABEL
DESCRIPTION
Mode
Select Routing (default) if your ISP allows multiple computers to share an Internet
account. Otherwise, select Bridge.
Encapsulation
Select the encapsulation type your ISP uses from the Encapsulation drop-down list
box. Choices vary depending on what you select in the Mode field.
If you select Bridge in the Mode field, select either PPPoA or RFC 1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or
If you select Bridge in the Mode field, select either PPPoA or RFC 1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or
PPPoE.
Multiplexing
Select the multiplexing method used by your ISP from the Multiplex drop-down list
box either VC-based or LLC-based.
Virtual Circuit
ID
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit.
Refer to the appendix for more information.
VPI
Enter the VPI assigned to you. This field may already be configured.
VCI
Enter the VCI assigned to you. This field may already be configured.
Back
Click Back to go back to the previous screen.
Next
Click Next to continue to the next wizard screen. The next wizard screen you see
depends on what mode and encapsulation you selected above.
Exit
Click Exit to close the wizard screen without saving your changes.