ZyXEL Communications wireless n gigabit netusb router ユーザーズマニュアル

Chapter 15 Wireless LAN

NBG4615 User’s Guide

Select WPA-PSK or WPA2-PSK from the Security Mode list.

Network > Wireless LAN > Security: WPA-PSK/WPA2-PSK

The following table describes the labels in this screen.

Key 1 to Key 4

The WEP keys are used to encrypt data. Both the NBG4615 and the wireless 
stations must use the same WEP key for data transmission.

If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal 
characters ("0-9", "A-F").

If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal 
characters ("0-9", "A-F"). 

You must configure at least one key, only one key can be activated at any one 
time. The default key is key 1.

Apply

Click Apply to save your changes back to the NBG4615.

Cancel

Click Cancel to reload the previous configuration for this screen.

Network > Wireless LAN > Security: Static WEP (continued)

Network > Wireless LAN > Security: WPA-PSK/WPA2-PSK

SSID

Select the SSID for which you want to configure the security.

Security Mode

Select WPA-PSK or WPA2-PSK to enable data encryption.

WPA Compatible

This field appears when you choose WPA2-PSK as the Security Mode.

Check this field to allow wireless devices using WPA-PSK security mode to 
connect to your NBG4615.

Pre-Shared Key 

WPA-PSK/WPA2-PSK uses a simple common password for authentication.

Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.

Group Key 
Update Timer

The Group Key Update Timer is the rate at which the AP sends a new group 
key out to all clients. 

The default is 3600 seconds (60 minutes).

Apply

Click Apply to save your changes back to the NBG4615.

Cancel

Click Cancel to reload the previous configuration for this screen.