ZyXEL Communications P-2302HW-P1 Series ユーザーズマニュアル
P-2302HW/HWL-P1 Series User’s Guide
Chapter 5 Wireless LAN
97
5.4.4 WPA(2) Authentication Screen
In order to configure and enable WPA Authentication; click the Wireless LAN link under
Network to display the Wireless screen. Select WPA or WPA2 from the Security list.
Network to display the Wireless screen. Select WPA or WPA2 from the Security list.
Figure 43 Wireless: WPA(2)
Idle Timeout
The ZyXEL Device automatically disconnects a wireless station from the wired
network after a period of inactivity. The wireless station needs to enter the
username and password again before access to the wired network is allowed. The
default time interval is 3600 seconds (or 1 hour).
network after a period of inactivity. The wireless station needs to enter the
username and password again before access to the wired network is allowed. The
default time interval is 3600 seconds (or 1 hour).
Group Key Update
Timer
Timer
The Group Key Update Timer is the rate at which the AP (if using WPA(2)-PSK
key management) or RADIUS server (if using WPA key management) sends a
new group key out to all clients. The re-keying process is the WPA equivalent of
automatically changing the WEP key for an AP and all stations in a WLAN on a
periodic basis. Setting of the Group Key Update Timer is also supported in WPA-
PSK mode. The ZyXEL Device default is 1800 seconds (30 minutes).
key management) or RADIUS server (if using WPA key management) sends a
new group key out to all clients. The re-keying process is the WPA equivalent of
automatically changing the WEP key for an AP and all stations in a WLAN on a
periodic basis. Setting of the Group Key Update Timer is also supported in WPA-
PSK mode. The ZyXEL Device default is 1800 seconds (30 minutes).
Table 37 Wireless: WPA(2)-PSK
LABEL
DESCRIPTION