ZyXEL Communications MES3500-24F ユーザーズマニュアル
Chapter 11 Static Multicast Forward Setup
MES3500-24/24F User’s Guide
118
Click Advanced Application > Static Multicast Forwarding to display the configuration screen
as shown.
as shown.
Figure 50
Advanced Application > Static Multicast Forwarding
The following table describes the labels in this screen.
Table 23
Advanced Application > Static Multicast Forwarding
LABEL
DESCRIPTION
Active
Select this check box to activate your rule. You may temporarily deactivate a rule without
deleting it by clearing this check box.
deleting it by clearing this check box.
Name
Type a descriptive name (up to 32 printable ASCII characters) for this static multicast MAC
address forwarding rule. This is for identification only.
address forwarding rule. This is for identification only.
MAC Address
Enter a multicast MAC address which identifies the multicast group. The last binary bit of the
first octet pair in a multicast MAC address must be 1. For example, the first octet pair
00000001 is 01 and 00000011 is 03 in hexadecimal, so 01:00:5e:00:00:0A and
03:00:5e:00:00:27 are valid multicast MAC addresses.
first octet pair in a multicast MAC address must be 1. For example, the first octet pair
00000001 is 01 and 00000011 is 03 in hexadecimal, so 01:00:5e:00:00:0A and
03:00:5e:00:00:27 are valid multicast MAC addresses.
VID
You can forward frames with matching destination MAC address to port(s) within a VLAN
group. Enter the ID that identifies the VLAN group here. If you don’t have a specific target
VLAN, enter 1.
group. Enter the ID that identifies the VLAN group here. If you don’t have a specific target
VLAN, enter 1.
Port
Enter the port(s) where frames with destination MAC address that matched the entry above
are forwarded. You can enter multiple ports separated by (no space) comma (,) or hyphen (-
). For example, enter “3-5” for ports 3, 4, and 5. Enter “3,5,7” for ports 3, 5, and 7.
are forwarded. You can enter multiple ports separated by (no space) comma (,) or hyphen (-
). For example, enter “3-5” for ports 3, 4, and 5. Enter “3,5,7” for ports 3, 5, and 7.
Add
Click Add to save your rule to the Switch’s run-time memory. The Switch loses this rule if it is
turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to reset the fields to their last saved values.
Clear
Click Clear to begin configuring this screen afresh.
Index
Click an index number to modify a static multicast MAC address rule for port(s).
Active
This field displays whether a static multicast MAC address forwarding rule is active (Yes) or
not (No). You may temporarily deactivate a rule without deleting it.
not (No). You may temporarily deactivate a rule without deleting it.
Name
This field displays the descriptive name for identification purposes for a static multicast MAC
address-forwarding rule.
address-forwarding rule.
MAC Address
This field displays the multicast MAC address that identifies a multicast group.
VID
This field displays the ID number of a VLAN group to which frames containing the specified
multicast MAC address will be forwarded.
multicast MAC address will be forwarded.