Patton electronic 07MOS10xx-GS ユーザーズマニュアル

OnSite System Installation

OnSite Series Getting Started Guide 

Take care to load the rack so that it is not top heavy.

Do not cover vents that would restrict airflow. Leave a minimum of a 
half-rack space above and below the OS-10 system for adequate ven-
tilation.

3. Secure the chassis using four 12-24 x 3/4-inch screws (two screws for each side) through the elongated 

holes in the L bracket nearest to the chassis and to the threaded holes in the mounting post. Use a suitable 
screwdriver for this task.

4. Tighten any loose captive installation screws on the expansion slot front panel covers.

Figure 10. Mounting the OS-10 System Chassis in an EIA/TIA 19-Inch Rack

To install the OS-10 system chassis in an ETSI 300-mm rack, see 

 and follow these steps:

1. Install the two L mounting brackets in the orientation shown in 

. Insert and fully tighten the 

screws to secure the brackets to the chassis (four screws for each bracket). Use a suitable screwdriver for this 
task.

For this rack configuration, the L mounting bracket holes are posi-
tioned 50 mm back from the front panel of the OS-10 system, as 
shown in 

.

2. Position the chassis in the rack and align the mounting holes in the L bracket with the mounting holes in 

the equipment rack.

The mounting-hole pitch for the ETSI 300 mm rack is 25 mm.

Take care to load the rack so that it is not top heavy.