Patton electronic 07MOS10xx-GS ユーザーズマニュアル
Gaining Access to the System
44
OnSite Series Getting Started Guide
4 • System Management Access
8. Type the following CLI command to save the IP settings (address, net mask, and default gateway)for the
Ethernet LAN management port to the system configuration file, and then press the Enter key:
save config
Note
Saving the configuration is important to prevent the loss of the IP
configuration data if a system reset or reboot occurs.
configuration data if a system reset or reboot occurs.
At this point, the system responds with Configuration Saved to indicate that the IP settings have been saved to
the system. The system is now ready for operation using the Web-based management interface.
the system. The system is now ready for operation using the Web-based management interface.
Note
You may also have access to the system through Telnet. This access
requires prior configuration of the IP address of the Ethernet LAN
management port through the RS-232 SERIAL port, as indicated in
the preceding steps.
requires prior configuration of the IP address of the Ethernet LAN
management port through the RS-232 SERIAL port, as indicated in
the preceding steps.
Note
The system terminates the management session for any user when the
session remains inactive for 30 seconds. This termination applies to
management sessions through the SERIAL port or through Telnet.
The login prompt appears when the system terminates a previously
active session through the SERIAL port.
session remains inactive for 30 seconds. This termination applies to
management sessions through the SERIAL port or through Telnet.
The login prompt appears when the system terminates a previously
active session through the SERIAL port.
Access through the Ethernet LAN Management Port
To gain management access to the system for the first time through the Ethernet LAN management (LM) port,
follow these steps:
follow these steps:
1. Connect a PC to the Ethernet LAN management port using the RJ-45 connector.
Note
You may connect the PC to the system from a remote location using
an IP LAN or WAN that connects to the Ethernet LAN management
port.
an IP LAN or WAN that connects to the Ethernet LAN management
port.
2. Configure the PC using the factory default settings for the Ethernet LAN management port.
Note
By default, the IP address is set to 192.168.2.100, the net mask is set
to 255.255.255.0, and the default gateway is set to 192.168.2.1
to 255.255.255.0, and the default gateway is set to 192.168.2.1
3. Launch the Web browser of your choice, and type the default IP address of the system in the Address field
of the browser.
4. Log in to the system using the super, admin, or monitor user ID and password.
Note
The factory-assigned default password for the Super user is super (all
lowercase letters).
lowercase letters).
Changing the IP address, net mask, and default gateway settings
for the Ethernet LAN management port could result in the loss-of-
management connectivity to the system, if the connection is cur-
rently through that port.
for the Ethernet LAN management port could result in the loss-of-
management connectivity to the system, if the connection is cur-
rently through that port.
CAUTION