Alcatel Carrier Internetworking Solutions Switch/Router ユーザーズマニュアル

Page 36-2

•

Mammoth 

VBUS

 Test

•

Pseudo 

CAM

 Test

•

Port Traffic Test

•

Port Stress Test (available for Ethernet modules)

•

Submodule Local Memory Test

•

SUNI

 Register Test

•

Telluride Register Test

•

Whistler Register Test

•

WSX

 Cable Connection Test

•

Alcatel 

CAM

 Off-Board Test

You must log in to the 

 account to access the hardware diagnostics functionality or use 

the 

 and command.

There are several image files used for hardware diagnostics. These files have the following 
uses:

•

Omni Switch/Router diagnostics image file

•

Omni Switch/Router stress test image file

♦ Note ♦

To function properly, hardware diagnostics must be run 
offline (i.e., the switch should not be connected to a 
network) or during network downtimes. In addition, 
spanning tree must be set to 

 via the 

 command. 

For details on using the 

 command, see Chapter 17, 

“Configuring Bridging Parameters.”

The 

OK2

 

LED

 of the module under test will be set to red if a failure is detected by diagnostic 

testing. The 

OK2

 

LED

 can be restored by resetting the module or by rebooting the chassis.

Diagnostics may not run if the 

 and 

 files are not in their default configura-

tions. In addition, some diagnostics may affect the settings in configuration files. Therefore, 
any customized 

 and 

 files should be saved prior to testing. Once testing is 

completed, these files should be restored and the chassis rebooted prior to normal operation.

The default 

 and 

 files are obtained by performing the following steps:

1. Remove these files from flash memory by renaming the files to names besides 

 

and 

. For example, you can rename 

 to 

 to highlight the fact 

that it is the original version of the file.

2. Delete the 

 and 

 files from flash memory.

3. Reboot the system. The MPX will create default 

 and 

 files when these 

files are missing from flash memory. These default files are the ones to be used with diag-
nostic software.