Alcatel Carrier Internetworking Solutions Switch/Router ユーザーズマニュアル

Page 36-5

The 

 command provides a way of modifying the behavior of the temperature alarm to 

mask the effect of the temperature sensor. By masking the temperature alarm bits, you can 
ensure that the 

MPX

’s 

TEMP LED

 doesn’t signal or that it resets after a specified delay time. By 

default, temperature masking is disabled.

To enable temperature masking, enter

This command masks the temperature alarm completely. The 

TEMP LED

 will not signal, even 

if the temperature exceeds the set ranges. The following message confirms the masking:

You could also enable temperature alarm masking but not mask the alarm completely. If you 
enter an integer after the 

 command, the 

TEMP LED

 will still signal, but it will 

reset after the number of minutes you specified. For example, if you enter the command

the temperature alarm will still signal, but it will reset automatically five (5) minutes after the 
alarm-initiating event occurs. 

♦ Note ♦

Once you enter a minute value when enabling 
temperature alarm masking, that value is saved even 
if you disable masking. To reset the minute value, you 
must re-enable temperature alarm masking and set the 
minute value to zero (i.e., enter the command 

).

To disable temperature alarm masking, enter:

This is the default setting, so you only need to specify this command if you had previously 
enabled alarm masking. The following message confirms that you disabled masking: