Alcatel Carrier Internetworking Solutions Switch/Router ユーザーズマニュアル
User Interface Display Options
Page 4-30
User Interface Display Options
The System menu several commands to configure help information, character display, and the
system prompt for the
system prompt for the
UI
. Enter
system
at the system prompt to enter the System menu. Press the question mark (
?
) to see the System
menu commands, as shown below.
Command
System Menu
info
Basic info on this system
dt
Set system date and time
ser
View or configure the DTE or DCE port
mpm
Configure a Management Processor Module
slot
View Slot Table information
systat
View system stats related to system, power and environment
taskstat
View task utilization stats
memstat
View memory use statistics
fsck
Perform a file system check on the flash file system
newfs
Erase all files from /flash & create a new file system
syscfg
View/Configure info related to this system
uic
UI configuration; change - prompt, timeout, more, verbose.
camstat
View CAM info and usage
camcfg
Configure CAM info and usage
hrex
Enter HRE-X management command sub-menu
ver/ter
Enables/disables automatic display of menus on entry (obsolete,
use ‘uic’ command)
echo/noecho
Enable/disable character echo
chpr
Change the prompt for the system (obsolete, use ‘uic’ command)
logging
View system logs.
health
Set health parameters or view health statistics
cli/exit
Enter command line interface
saveconfig
Dump the cache configuration content to the mpm.cfg file.
cacheconfig
Set the flag to use cache configuration only.
Main
File
Summary VLAN
Networking
Interface Security
System
Services
Help
For information on the
info
,
dt
,
ser
,
slot
,
systat
,
taskstat
,
memstat
,
fsck
,
newfs
,
syscfg
,
camstat
,
camcfg
, and
hrex
commands, refer to Chapter 9, “Switch-Wide Parameters.” The
mpm
command is described in Chapter 6, “Configuring Management Processor Modules.” The
ver/
ter
and
chpr
echo/noecho
command is described in the following section. The
cli
The
logging
command is described in Chapter 10, “Switch Logging.”
♦ Note ♦
The
ver
/
ter
, and
chpr
commands now appear as items
in the
UI
Configuration menu (displayed through the
uic
command). If you enter the
ver
/
ter
and
chpr
commands, a message will advise you to use the
uic
command, and the
UI
Configuration menu will auto-
matically display. For more information on the
UI