Alcatel Carrier Internetworking Solutions Switch/Router ユーザーズマニュアル

Page 9-15

The 

command displays statistics related to system, power, and environment. To view 

these parameters, enter

at the system prompt. A screen similar to the following will be displayed.

The fields displayed by the 

 command are described below.

. The time since the last boot that the system has been running, displayed in 

days, hours, minutes, and seconds (to the nearest hundredth).

. The number of times a 

VSE

 transmit buffer could not be allocated by a 

task on the 

MPX

. 

. The number of times packets were dropped because the bus had more 

packets to deliver than the 

MPX

 could handle. This is a “receive overrun” condition which can 

happen when a storm occurs or when the switch is first powered up and many unknown 

MAC

 frames are being forwarded to the 

MPX

.

. The amount of total memory installed on the 

MPX

.

. The amount of free, or unused, memory available in the 

MPX

. This data is 

also displayed by the 

 command, which is described in Viewing MPX Memory Statis-

. The amount of time, by percent, the 

MPX

 processor actually 

worked during the last 5 seconds.

. The amount of time, by percent, that the 

MPX

 processor actually 

did work during the last minute.

. Valid states are 

, 

, and 

. A power supply that has been 

turned off will be in the 

 state. If not installed, it will be in the 

 state.

. Valid states are 

, 

, and 

. A power supply that has been 

turned off will be in the 

 state. If not installed, it will be in the 

 state.

. Indicates whether the 

MPX

 temperature sensor detects overheating. Valid 

states are 

, 

, and 

.

. Indicates the switch temperature Celsius and Fahrenheit.

. Indicates whether temperature alarm masking is Enabled or 

Disabled. You enable masking through the 

 command, which is described in Chapter 

36, “Running Hardware Diagnostics.”