Alcatel Carrier Internetworking Solutions Switch/Router ユーザーズマニュアル
NTP Configuration Menu
Page 12-7
Field Descriptions
The following section describes the fields displayed using the
ntpconfig
command.
1) Response timeout
This field sets the timeout period for responses to server queries. Server queries come from
the server responsible for providing this client with
the server responsible for providing this client with
NTP
time information. The default is 8000
milliseconds.
2) Authentication delay
This field sets a specified time interval that is added to timestamps included in requests to the
server that required authentication. Typically this delay is needed in cases of long delay paths,
or of servers whose clocks are unsynchronized.
server that required authentication. Typically this delay is needed in cases of long delay paths,
or of servers whose clocks are unsynchronized.
3) Authentication key file name
The key file is a file that holds the
NTP
authentication keys used during remote access or
configuration of the server responsible for this client. This fields allows you to specify the
name of the key file. The key file should be kept in the
name of the key file. The key file should be kept in the
/flash
directory of the switch.
Specifying a key file expands the
NTP
Startup Configuration menu. For more information on
4) NTP client mode
This field allows you to set how the client mode of this device sends its server queries. The
options are
options are
U
(for unicast),
B
(for broadcast), or
M
(for multicast).
Setting the
NTP
client mode to broadcast or multicast expands the
NTP
Startup Configuration
menu. A suboption for the
NTP
client mode appears, allowing you to specify the broadcast or
multicast address, as shown:
41) NTP multicast address
:
Enter the broadcast of multicast address at the prompt by typing line number
41
, and equal
sign (
=
), and the
IP
address. For example, to specify a multicast address of 204.0.1.1, you
would enter the following:
41=204.0.1.1
5) Enable monitor
This field turns
NTP
monitoring on or off. Entering
yes
activates
NTP
monitoring, while enter-
ing
no
deactivates this function. The statistics for monitoring can be viewed using the
ntpmon
6) Enable NTP server
This field allows you to enable the server portion of the
NTP
software for this
NTP
device.
When set to
yes
, this device can act as an
NTP
server for other clients. When set to
no
, this
device is only a client of another
NTP
server.