Alcatel Carrier Internetworking Solutions Switch/Router ユーザーズマニュアル

Page 1-2

Currently, Omni Switch/Router switching modules consist of Gigabit Ethernet modules, auto-
sensing Ethernet modules, Fast 10/100 Ethernet modules, 10 Mbps Ethernet modules, 

WAN

 

modules, and Voice Over IP (

VOIP

) modules. See Chapter 3, “Omni Switch/Router Switching 

Modules,” for documentation.

♦ Important Note ♦

Omni Switch/Router modules require the use of an 
Omni Switch/Router chassis (see Omni Switch/Router 
Chassis and Power Supplies on page 1-7). Do not 
install an Omni Switch/Router module in an 
OmniSwitch chassis and do not install an OmniSwitch 
module in an Omni Switch/Router chassis.

Omni Switch/Router hardware uses the same User Interface (

UI

) commands and Network 

Management Software (

NMS

) as OmniSwitch hardware. Omni Switch/Router modules support 

broadcast management, multicast management, any-to-any switching, virtual 

LANs

 (

VLANs

), 

firewalls, user authentication, 

WAN

 access, and policy-based configuration.

♦ Important Note ♦

In Release 4.4 and later, the Omni Switch/Router is 
factory-configured to boot up in 

CLI

 (Command Line 

Interface) mode, rather than in 

UI

 (User Interface) 

mode. Chapter 4, “The User Interface,” includes docu-
mentation on changing from 

CLI 

mode to 

UI

 mode.

You need Release 3.4, or higher, of Alcatel’s X-Vision Network Management Software (

NMS

) 

to operate with Omni Switch/Router hardware.