Alcatel Carrier Internetworking Solutions Switch/Router ユーザーズマニュアル
Bridging Commands
Page 17-12
2. To modify an entry, use the index number for the specific static bridge address (listed in
the leftmost column), the column letter for the column you want to change, an equal sign,
and a new value. For example, to change the
and a new value. For example, to change the
Static Status
of the first address’s in the table
from
permanent
to
deleteOnReset
, you would enter a
1
(the static bridge address
Index
number), a
b
(the column letter for
Static Status
), an equal sign (
=
), and the number
4
(the
value for
deleteOnReset
), as shown:
1b=4
3. Press
<return>
to complete the operation.
4. Type
save
at the
fc
command prompt to save the changes.
Deleting a Static Bridge Address
Deleting a previously created static bridge address is much the same process as modifying a
Static Bridge Address. To delete a Static Bridge Address, follow these steps:
Static Bridge Address. To delete a Static Bridge Address, follow these steps:
1. Enter the
fc
command as documented above. The Bridge Static Address table will display
as shown:
Bridge Static Address for Group 2 (Default GROUP (#2))
Index
MAC Address Slot/Intf/Service/Inst Static Status
(A)
(B)
--------
-----------------------
------------------------------
---------------------
1
21A33E:00B001
3/
1/
Brg/1
permanent
2
001122:223344
3/
2/
Brg/1
deleteOnReset
The entries can be modified by specifying the index and column.
For Static Status, use 2 to delete, 3 for Permanent,
4 for Delete on Reset, 5 for Delete on Timeout
To add an entry: Use command 'add MAC addr, receiving port, static status'.
Receiving port and Status must be provided.
Port could either be slot/intf or virtual port begin with v.
For non-canonical MAC format add 'nc' before MAC.
ie: add 123456:7890AB, 2/3, 3 or add nc001122:334455, v99, 3
NOTE: add command will be executed immediately.
save|cancel|next only applies to existing entry.
add|save|cancel|next :
For Static Status, use 2 to delete, 3 for Permanent,
4 for Delete on Reset, 5 for Delete on Timeout
To add an entry: Use command 'add MAC addr, receiving port, static status'.
Receiving port and Status must be provided.
Port could either be slot/intf or virtual port begin with v.
For non-canonical MAC format add 'nc' before MAC.
ie: add 123456:7890AB, 2/3, 3 or add nc001122:334455, v99, 3
NOTE: add command will be executed immediately.
save|cancel|next only applies to existing entry.
add|save|cancel|next :
2. To delete an entry, use the index number for the specific static bridge address, the
column letter
b
(the column letter for
Static Status
), an equal sign (
=
), and a
2
(the value
for
Delete
).
For example, to delete the first address in the table, you would enter a
1
(the static bridge
address
Index
number), a
b
(the column letter for
Static Status
), an equal sign (
=
), and the
number
2
(the value for
Delete
), as shown:
1b=2
3. Press
<return>
to complete the operation.
4. Type
save
at the
fc
command prompt to save the changes. The
Static Status
will change to
Invalid
. Once you exit the
fc
command, the Static Bridge Address is removed from the
table.