Alcatel Carrier Internetworking Solutions Switch/Router ユーザーズマニュアル
The Switch Menu
Page 18-25
The Switch Menu
The switch menu contains commands that allow you to set translation options discussed
earlier in this chapter. It also contains commands to change the default values.
earlier in this chapter. It also contains commands to change the default values.
To view the switch menu, enter
switch
at the prompt. If you are in verbose mode, the follow-
ing screen is displayed. Otherwise, type a
?
at the switch menu prompt to display the Switch
Menu:
Command
Switch Menu
----------------------
---------------------------------------------------------------------------------------------------
propipx
Configure Default Proprietary IPX Token Ring to any switching
facdef
Configure Defaults to Factory values
ethdef
Configure Default Ethernet Translation
fddidef
Configure Default FDDI Translation
trdef
Configure Default TR Translation
swch
Configure Any To Any Switching Port Translations
swchmac
View per MAC Translation Options
autoencaps
Turn AutoTracker translations On or OFF
The commands above and their operations are described in the sections below.
Proprietary IPX Token Ring
The propipx command allows you to turn on or off the default proprietary IPX switch transla-
tion. (Refer to Appendix B, “Output Translation Options,” for information on the Proprietary
IPX feature.)
tion. (Refer to Appendix B, “Output Translation Options,” for information on the Proprietary
IPX feature.)
To turn on the Proprietary IPX feature (the default), enter the following at the system prompt:
propipx on
A message is displayed to confirm the activation of the Proprietary IPX feature. Please note
that the switch must be rebooted for the setting to take effect.
that the switch must be rebooted for the setting to take effect.
To turn off the Proprietary IPX feature type:
propipx off
Factory Defaults
You can reset all ports in the switch to their default factory settings. Any custom translations
you configured through
you configured through
modvp
,
ethdef
,
fddidef
,
trdef
, or
swch
commands will be overridden by
the default translation for the given media type (i.e., Ethernet, FDDI, etc.). Factory defaults for
each media type are described earlier in this chapter.
each media type are described earlier in this chapter.
To reset to factory defaults, enter the
facdef
command at the system prompt. The following
screen displays:
This will reset the default translations for each media type to a factory default.
It will then set all port translation options to inherit these defaults.
It will then reset the forwarding table translation options for all addresses learnt on
those ports to those port defaults.
Do you want to do this? (no):
It will then set all port translation options to inherit these defaults.
It will then reset the forwarding table translation options for all addresses learnt on
those ports to those port defaults.
Do you want to do this? (no):
Enter a
Y
to reset all port settings.