Alcatel Carrier Internetworking Solutions Switch/Router ユーザーズマニュアル

Page 20-10

a. To specify a protocol by Ethernet type, enter 

at the 

 menu. The follow-

ing prompt displays:

b. Enter the desired Ethernet type in hex. You must enter two bytes of data. For exam-

ple, enter 0800 to specify 

IP

 or enter 0806 to specify 

ARP

. All devices that use the 

specified Ethernet type will be members of the mobile group or AutoTracker 

VLAN

.

c. Go on to Step 4 below.

a. To specify a protocol by 

SAP

 (service access protocol) header, enter 

at the 

 menu. The following prompt displays:

b. Enter the destination service access protocol (

DSAP

) value in hex and press 

. 

The following prompt displays:

c. Enter the source service access protocol (

SSAP

) value in hex. Each entry must consist 

of one byte of data. All devices that use the specified source and destination 

SAP

 types 

will be members of the mobile group or AutoTracker 

VLAN

.

d. Go on to Step 4 below.

a. To specify a protocol by 

SNAP

 (sub-network access protocol) type, enter 

at the 

 menu. The following prompt displays:

b. Enter the desired 

SNAP

 value in hex. You must enter five bytes of data. For example, 

enter 

0000008137

 to specify 

IPX SNAP

 or enter 

00000080F3

 to specify AppleTalk 

ARP

 

SNAP

. All devices that use the specified 

SNAP

 type will be members of the mobile 

group or AutoTracker 

VLAN

.

c. Go on to Step 4 below.

4. The following prompt displays:

You can set up multiple rules for the same mobile group or AutoTracker 

VLAN

. Enter a 

 

here if you want to set up more rules in addition to the protocol rule specified here. If 
you enter 

, you will be prompted for the next rule that you want to set up. Follow the 

directions in the appropriate section to configure that rule.

If you enter 

, you will receive a message, similar to the one below, indicating that the 

VLAN

 was set up.

You are done setting up rules for this mobile group or AutoTracker 

VLAN

.