Alcatel Carrier Internetworking Solutions Switch/Router ユーザーズマニュアル
Configuring IP RIP Filters
Page 25-34
4. The following prompt displays:
IP address (default: all networks) :
Enter the IP address of the network that is to be allowed or blocked by the filter (or just
press
press
Enter
to use the default of all networks). If you choose the default you will not be
prompted for the network mask (as is shown in the next step).
5. The following prompt displays:
IP network mask (default: 255.255.255.0) :
Enter the IP network mask of the network that is to be allowed or blocked by the filter
(or just press
(or just press
Enter
to use the default mask of 255.255.255.0). Note that the default mask
will vary depending on the class of the IP address you entered above.
6. A message displays indicating that the filter was successfully added:
ipfilter successfully added
Adding an IP RIP Filter For a Specific Group or VLAN
Follow the steps below to add an IP RIP Output or Input filter for a specific Group or
VLAN
.
1. Enter the Group and
VLAN
numbers after the command like this:
ipfilter 1:1.
A screen similar to the following displays:
Selecting IP filter for interface 1:1 :
Add or delete entry {add(a), delete(d)} (a) :
Filter action {block(b), allow(a)} (a) :
IP address (default: all networks) :
IP network mask (default: 255.255.255.0) :
IP address (default: all networks) :
IP network mask (default: 255.255.255.0) :
ipfilter successfully added
Enter
a
(or just press
Enter
) to select to add a filter.
2. The following prompt displays:
Filter type{RIP Output(ro),
RIP Input(ri)} (ro) :
Enter
ro
(or just press
Enter
) to add a RIP Output filter. Enter
ri
to add a RIP Input filter.
3. The following prompt displays:
Filter action {block(b), allow(a)} (a) :
Enter
a
(or press
Enter
) to set the filter action to “allow.” Enter
b
to set the filter action to
“block.”
4. The following prompt displays:
IP address (default: all networks) :
Enter the IP address of the network that is to be allowed or blocked by the filter (or press
Enter
to use the default of all networks). If you choose the default you will not be
prompted for the network mask (as is shown in the next step).