Alcatel Carrier Internetworking Solutions Switch/Router ユーザーズマニュアル

Page 29-36

You can delete a 

WSX

 port or virtual circuit. When you delete a port or virtual circuit all 

configuration parameters revert back to default settings. You can use the 

 command to 

delete:

• a single virtual circuit, or

• a port and all of its associated virtual circuits

The 

 command always requires you to indicate at least a slot and port number. You 

cannot, for example, enter 

 along with no slot and port parameters.

You can delete a single virtual circuit as long as you know its 

DLCI

 number and the 

WSX

 port 

where it exists. Deleting a virtual circuit resets the configuration parameters on that circuit to 
configuration and bridging defaults. By default, a virtual circuit is assigned to Group 1.

Virtual circuits are also not actually “deleted” when you use 

. The Frame Relay 

network stills sees them as active or inactive. If the virtual circuit was configured (manage-
ment circuit or a circuit configured through 

), then the database record for the circuit 

is deleted; the VC is still present as long as it was present before you deleted it. If the virtual 
circuit is learned (through status updates from the Frame Relay network), then the database 
record for the circuit is deleted, but the circuit is still present.

To delete a virtual circuit, enter the following command

where 

 is the Omni Switch/Router slot number for the 

WSX

 board, 

 is the port to 

which the virtual circuit maps, and 

 is the identification number for the virtual circuit. 

For example, if you wanted to delete virtual circuit 32 on Port 1 of the 

WSX

 board in slot 2, 

then would enter:

or

This system returns the following prompt to confirm the deletion:

Enter a 

 to confirm the deletion or press 

 to cancel the deletion.