HP (Hewlett-Packard) E3000 MPE/IX ユーザーズマニュアル

Configuring Logging

NetIPC logging is automatically activated at system start up. Link
manager logging and network transport logging are activated when you
initiate the network transport (

NETCONTROL START

). Network Services

logging is activated when the Network Services are initiated (that is,
when the

NSCONTROL START

 command is issued).

Network Link logging is activated when the specific link is first started.

When you are changing a logging configuration for a specific subsystem,
the changes will normally take effect when you perform a

SWITCHNMLOG

UPDATE

 command. In some cases, however, such as when no logging is

currently active, the subsystem may need to be deactivated and
restarted. The steps that must be taken for each subsystem are shown
in Table 13-1.

How to use the log messages for troubleshooting is described in the
NS 3000/iX Error Messages Reference Manual. How to format the log
file for examination is described in Using the Node Management
Services (NMS) Utilities.

Network Transport

NETCONTROL STOP

 (if already active)

NETCONTROL START

NetIPC (sockets)

NETCONTROL STOP

 (if already active)

NETCONTROL START

NETCONTROL UPDATE

Network Services

NSCONTROL STOP

 (if already active)

NSCONTROL START

Link Manager

NETCONTROL STOP

 (if already active)

SNACONTROL STOP;node=nodename

(refer to

the SNA Link/XL Node Manger’s Guide)

SNACONTROL START;NODE=nodename

NETCONTROL START

Link Logging (non-DTS)

NETCONTROL STOP

; NET = niname

(if already active)

NETCONTROL START

; NET = niname

Link Logging (DTS link)

Restart the system or use :DTCCNTRL option
4 (shutdown) followed by option 5 (restart).