HP (Hewlett-Packard) E3000 MPE/IX ユーザーズマニュアル

Configuring a LAN Node

The Token Ring Configuration screen (#49) in Figure 6-3 is displayed
when you press the

 key at the Network Transport

Configuration screen (#42) with an NI type of

6

 (Token Ring). Refer to

Chapter 5 , “Introductory Screens,” for information on the Network
Transport Configuration screen.

Step 1. In the

IP address

field, enter the internet protocol (IP) address for the

node being configured. An example of an address is

C 192.191.191 009

.

Step 2. The IP subnet mask is optional. If entering one, tab to the

IP subnet

mask

 field and enter the number in the same format as an IP address.

Step 3. Move to the

Link name

field. Enter a link name to represent the Token

Ring card for which you are configuring a link. This name must be
unique to the node.

Step 4. Tab down to the field called

Physical Path of Token Ring Device

Adapter

. Enter the physical path number corresponding to the SPU

slot number where the Token Ring device adapter is located.

If the same Token Ring card is being used for both NS and SNA
communications, you must use the same value for this field as is
configured for the SNA Link.