HP (Hewlett-Packard) E3000/IX ユーザーズマニュアル

Configuring a X.25 Node

An address key called

POOL

 is already preconfigured for you though it

doesn’t show up on the screen.

POOL

allows the node being configured to

receive any incoming calls even if the remote system’s address is not
configured on this screen.

POOL

 will also allow you to use NetIPC to

programmatically provide an X.25 address that is not configured on this
screen. If you want to delete the

POOL

address key, in the last line of the

X.25 Virtual Circuit Configuration screen enter a

3

 (for switched VCs)

and press the

key. That brings you to the X.25 SVC Address Key

Paths screen where you can then remove the default name

 POOL

 by

typing over it with spaces and then saving the data.

Step 4. If the address type is a switched virtual circuit complete steps a

through c, but if the address type is a permanent virtual circuit, skip to
step 5.

a. In the

Remote X.25 address

 field, enter the X.25 address of the

remote host for X.25 public data networks or private networks.

b. Make sure the name of the facility set you are using is in the

Facility set

 field. You may either choose the default facility set

(

STDSFSET

) or enter an alternative. If you are configuring a new

facility set, enter a new name. (To modify facility set parameters,
enter a

5

 in the last field on the screen and press the

 key.)

c. In the

Security class

 field, enter the level of logical security you

want to have on this particular entry. The possible values are

IN

(accept calls from the address),

IO

 (accept calls from and send calls

to the address, default),

OU

(send calls to the address, incoming calls

are rejected), and

LK

 (block calls to or from the address).

Step 5. If the address type is a permanent virtual circuit (PVC), in the

Permanent VC number

 field, enter the PVC number of the PVC on the

remote node. This value cannot be greater than the number of PVCs for
which you are subscribed. It must be within the PVC range you defined
during DTC configuration.

Step 6. After you have finished entering new information for each remote node,

press the

 key. (Press the key once for each remote node you

are configuring.)

Step 7. If you have completed configuration of X.25, press the

key and proceed to Chapter 10 , “Validating and Cross-Validating with
SYSGEN.” Otherwise, press the

 key to return to the X.25

Configuration screen.

Network directory name

The network directory file that will be updated by the
information entered through this screen.