Klark Teknik DN9652 ユーザーズマニュアル
Configuring the unit for the first time
DN9650/DN9652 Network Bridge
Operator Manual
Operator Manual
5
6
The DN965X NETWORK BRIDGE
CONFIGURATION menu will open in
the web browser’s Klark Teknik
DN965X Configuration tab.
CONFIGURATION menu will open in
the web browser’s Klark Teknik
DN965X Configuration tab.
>> To select which network card(s) are fitted in the unit
1
In the configuration menu, click
Change Module Type in the desired
network module section. If no network
module type has been set up, its
section will look similar to the one
shown right. On the DN9650, network
module B is always a Klark Teknik
3-Port AES50 Module.
Change Module Type in the desired
network module section. If no network
module type has been set up, its
section will look similar to the one
shown right. On the DN9650, network
module B is always a Klark Teknik
3-Port AES50 Module.
For details of which network module section on the configuration menu applies
which network module card fitted in the rear panel of the unit, see Figure 2
“Typical configuration menu” on page 18 and Figure 1 “Rear panel of the
DN965X” on page 15.
which network module card fitted in the rear panel of the unit, see Figure 2
“Typical configuration menu” on page 18 and Figure 1 “Rear panel of the
DN965X” on page 15.
2
In the Change Network Module
Type window, select the appropriate
network module type and then click
OK.
Type window, select the appropriate
network module type and then click
OK.
3
Your DN965X is now ready for use as a network bridge. However, if you want to
change the settings of the network module cards, see “Setting up a network
module” on page 19
change the settings of the network module cards, see “Setting up a network
module” on page 19