Klark Teknik DN9652 ユーザーズマニュアル
Chapter 5: Configuring the DN965X
DN9650/DN9652 Network Bridge
24
Operator Manual
The unit will automatically reboot to apply the changes. At this point you must
monitor the reboot progress on the LCD display screen, which will show
the following messages, finally displaying the default. Note the IP address
during the reboot.
monitor the reboot progress on the LCD display screen, which will show
the following messages, finally displaying the default. Note the IP address
during the reboot.
7
When the default display appears, the DN965X has fully rebooted and it should
now be fully updated with the new software. Click the Click here to return to
the main page link on the to go back to the configuration page. Make sure that
the unit has been updated by checking the software version in the Unit
Software section.
now be fully updated with the new software. Click the Click here to return to
the main page link on the to go back to the configuration page. Make sure that
the unit has been updated by checking the software version in the Unit
Software section.
If you cannot get back to the configuration page, try typing in the IP address you
saw at reboot (see “To connect the DN965X to a computer and then open its
configuration menu in the web browser” on page 4).
saw at reboot (see “To connect the DN965X to a computer and then open its
configuration menu in the web browser” on page 4).
8
Your unit should now be fully upgraded and ready for operation.
Default display
Default IP address