Netgear RN10400100NAS ユーザーズマニュアル

1-64

Configuring Your ReadyNAS

and time. (The Power ON option is available on the ReadyNAS NV through an add-on package.)

1

 

The Power ON option does not appear if the ReadyNAS hardware does not support this feature.

If this device is not connection to a UPS device, you may ele4ct to enable a UPS connection to 
another NAS device. Select the Enable UPS attached to another NAS check box and enter the IP 
Address in the Remote IP field. NETGEAR recommends that you enable this feature if you have 
enabled the Disk Spin-Down option. 

If you use this option, the ReadyNAS is shut down automatically when a battery-low condition is 
detected on a UPS connected to another ReadyNAS. This is useful when a UPS is shared by 
multiple ReadyNAS units, even though only one ReadyNAS is monitoring the battery status.

As an option, the ReadyNAS can remotely monitor the UPS when connected to a PC running 
Network UPS Tools (NUT). For more information about NUT, see 

The Shutdown Options screen offers the option to either power off or reboot the ReadyNAS 
device. You also have the option of performing either a full file system check or a quota check on 
the next boot. Both these options can take several minutes to several hours depending on the size 
of your volume and the number of files in the volume. You do not need to select these options 
unless you suspect there might be data or quota integrity problems.

1. Please refer to the Release Notes for RAIDiator 3 on the NETGEAR Support site for more information.

Note: When the ReadyNAS is powered off, any file transfers and backup jobs are 

interrupted, and backup jobs scheduled during the power off state do not run.