Accton Technology Workgroup-3726M ユーザーズマニュアル
Quick Installation Guide
2
Installing the Switch
Before installing the switch verify that you have all the items listed under “Package
Contents.” If any of the items are missing or damaged, contact your local Accton
distributor. Also be sure you have all the necessary tools and cabling before
installing the switch. Note that this switch can be installed on any suitably large flat
surface or in a standard EIA 19-inch rack. After installing the switch, refer to the
Management Guide to set up its more advanced features, such as Spanning Tree
Protocol or VLAN port groups.
Contents.” If any of the items are missing or damaged, contact your local Accton
distributor. Also be sure you have all the necessary tools and cabling before
installing the switch. Note that this switch can be installed on any suitably large flat
surface or in a standard EIA 19-inch rack. After installing the switch, refer to the
Management Guide to set up its more advanced features, such as Spanning Tree
Protocol or VLAN port groups.
Package Contents
This package includes:
Description of Hardware
The base unit contains 24 10BASE-T/100BASE-TX ports, plus three slots on the
rear panel for various modules. A Management Module can be installed in the upper
slot on the rear panel (see “Installing a Management Module” on page 4). The
lower-left slot can be used for an optional media expansion module or Stacking
Module, while the lower-right slot can be used for a media expansion module. Note
that the media expansion modules include a Fast Ethernet fiber optic module with
two 100BASE-FX (SC type) ports or a one port Gigabit 1000BASE-SX (SC type), or
1000BASE-LX uplink module.
rear panel for various modules. A Management Module can be installed in the upper
slot on the rear panel (see “Installing a Management Module” on page 4). The
lower-left slot can be used for an optional media expansion module or Stacking
Module, while the lower-right slot can be used for a media expansion module. Note
that the media expansion modules include a Fast Ethernet fiber optic module with
two 100BASE-FX (SC type) ports or a one port Gigabit 1000BASE-SX (SC type), or
1000BASE-LX uplink module.
All RJ-45 ports on the base unit operate at 10 or 100 Mbps, and support
auto-negotiation of speed, duplex mode (i.e., half or full duplex), and flow control.
auto-negotiation of speed, duplex mode (i.e., half or full duplex), and flow control.
The 1000BASE-SX and 1000BASE-LX ports are fixed at 1000 Mbps but
auto-negotiate duplex mode. The 100BASE-FX module is fixed at the 100 Mbps, full
duplex. All media types can auto-negotiate flow control.
auto-negotiate duplex mode. The 100BASE-FX module is fixed at the 100 Mbps, full
duplex. All media types can auto-negotiate flow control.
Note that when using auto-negotiation, the speed, transmission mode and flow
control can be automatically set if this feature is also supported by the attached
device. Otherwise, these items can be manually configured for any connection.
control can be automatically set if this feature is also supported by the attached
device. Otherwise, these items can be manually configured for any connection.
The base unit also includes a display panel for key system and port indications that
simplify installation and network troubleshooting.
simplify installation and network troubleshooting.
• CheetahSwitch Workgroup-3726M (Model No. AC-ES3726M)
• Four rubber foot pads
• Four rubber foot pads
• This Quick Installation Guide
• Rack mount bracket kit
• Owner registration card
• AC power cord