Foundry Networks FGS624P ユーザーズマニュアル
Installing the FastIron GS Chassis
September 2007
© 2007 Foundry Networks, Inc.
3 - 7
4.
With one hand, hold the bar on the front panel of the power supply. With the other hand, support the
underside of the power supply, and insert the power supply into the empty power supply slot. Press until the
supply is completely in the slot, so that the connectors on the back of the supply fully engage with the pins on
the power backplane.
underside of the power supply, and insert the power supply into the empty power supply slot. Press until the
supply is completely in the slot, so that the connectors on the back of the supply fully engage with the pins on
the power backplane.
CAUTION:
Make sure you insert the power supply right-side up. It is possible to insert the supply upside down,
although the supply will not engage with the power backplane when upside down. The power supply is right-side
up when the power connector is on the left and the fan vent is on the right.
up when the power connector is on the left and the fan vent is on the right.
5.
Press the two latches near the edges of the supply outward to lock the supply in place.
6.
Replace the power supply locking screw.
7.
Install the power cord, as shown below.
Retaining Bale
AC Power Cord