Foundry Networks FGS624XGP-POE ユーザーズマニュアル
FastIron GS Compact Layer 2 Switch Hardware Installation Guide
7 - 18
© 2007 Foundry Networks, Inc.
September 2007
NOTE:
This function takes advantage of information stored and supplied by the XFP device. This information is
an optional feature of the Multi-Source Agreement standard defining the XFP interface. Not all component
suppliers have implemented this feature set. In such cases where the XFP device does not supply the information,
a “Not Available” message will be displayed for the specific port that the device is installed
suppliers have implemented this feature set. In such cases where the XFP device does not supply the information,
a “Not Available” message will be displayed for the specific port that the device is installed
Supported Media
The following media are currently available and supported by FastIron GD and LS devices:
•
CWDM80
•
CWDM100
•
LHA
•
LHB
•
1GE BXD
•
1GE BXU
•
100Mpbs BXD
•
100Mpbs BXU
•
SX2
•
100FX
•
100FX-1R
•
100FX-LR
•
OC12-MM
CLI Commands
The show media command displays module information including link length, vendor name, vendor part number,
vendor revision, and laser wavelength.
vendor revision, and laser wavelength.
[no] optical-monitor <alarm interval>
Use this command to configure monitoring for all ports (system-wide), a range or ports, or a single port. The
<alarm-interval> variable sets the interval in minutes between the sending of alarms and messages. The default
interval is three minutes. When monitoring is enabled, console messages, syslog messages, and SNMP traps are
sent when warranted by optical operating conditions, and a port is enabled.
<alarm-interval> variable sets the interval in minutes between the sending of alarms and messages. The default
interval is three minutes. When monitoring is enabled, console messages, syslog messages, and SNMP traps are
sent when warranted by optical operating conditions, and a port is enabled.
show optic port/slot_number
This command displays optical monitoring information as a result of the optical-monitor configuration command.
Information includes:
Information includes:
•
temperature
•
TX power
•
RX power
•
TX bias current
Status values are:
•
low-alarm
•
low-warn
•
normal
•
high-warn
•
high-alarm