Sanyo PLC-XU350K ユーザーズマニュアル

  Problem:

– Solutions

  No power

– Plug the power cord of the projector into the AC outlet.

 

– See if the POWER indicator lights red.

 

– Wait until the POWER indicator stops blinking to turn on the projector

again. The projector can be turned on after the POWER indicator
turns red. See page 18.

 

– Check the WARNING indicator. If the WARNING indicator lights red,

projector cannot be turned on. See page 59.
 

– Check the projection lamp. See page 62.

 

– Unlock the Key lock function for the projector. See page 54.

The initial display is not shown .           – Make sure Off or Countdown off are not chosen at display  
function. See page 46.

The initial display is not same              – Make sure User or Off are not chosen at Logo (select)
as the default set .                                      function. See page 47.

Input signal switches automatically .    – Make sure Input search function is adjusted properly. See page 45.
(or does not switch automatically)

when the projector is on and you     – That is the Filter warning icon. See page 56.
press the input button, an icon 
other than the Lamp mode icon 
appears.

An icon other than Input mode or       – That is the Lamp replacement icon or the Filter warning icon. See
Lamp mode icon appears .                        pages 56 or 62.

Image is out of focus .

– Adjust focus of the projector. See page 23.

 

– Provide proper distance between the projector and the projection

 

 screen. See page 13.

 

– Check the projection lens to see if it needs cleaning. See page 61.

 

– Moving the projector from a cool to warm place may result in  

 

 moisture condensation on the projection lens. In such cases, leave

 

 the projector off and wait until condensation evaporates.

Image is Left/Right reversed .

– Check the Ceiling/Rear function. See page 50.

Image is Top/Bottom reversed .

– Check the Top/Bottom function. See page 50.

Picture is not bright enough . 

– Check if the Contrast or Brightness are adjusted properly. See

 

 pages 34,41.

 

– Check if Image mode is selected properly. See pages 33,40.

 

– Check the lamp control function. See pages 25,53.

 

– Check the LAMP REPLACE indicator. If it lights, the end of lamp life

 

 is approaching. Replace the lamp with a new one promptly. See page

 

 62. 

Before calling your dealer or service center for assistance, check the items below once again.

– Make sure you have properly connected the projector to peripheral equipment as described on pages 14-16.
– Make sure all equipment is connected to AC outlet and the power is turned on.
– When the projector does not project an image from the connected computer, restart the computer.