Sanyo PLC-XU350K ユーザーズマニュアル
9
L R
Part Names and Functions
Rear Terminal
⑤
S-VIDEO IN
Connect the S-VIDEO output signal from video
equipment to this jack (p.15).
equipment to this jack (p.15).
⑧
AUDIO IN
Connect the audio output signal from video
equipment connected to
equipment connected to
⑤ or ⑨ to this jack.
For a mono audio signal (a single audio jack),
connect it to the L (MONO) jack (p.15).
connect it to the L (MONO) jack (p.15).
⑦
COMPUTER 1 / COMPUTER AUDIO IN
Connect the audio output (stereo) from a
computer or video equipment connected to
computer or video equipment connected to
②
or
③ to this jack. (pp14, 16)
⑨
VIDEO IN
Connect the composite video output signal to
this jack (p.15).
this jack (p.15).
②
COMPUTER IN 1 / COMPONENT IN
Connect output signal from a computer, RGB scart
21-pin video output or component video output to
this terminal(pp.14,16).
21-pin video output or component video output to
this terminal(pp.14,16).
⑥ AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.14-16).
(pp.14-16).
This terminal outputs sound from AUDIO IN
terminal (
terminal (
⑦ or ⑧).
④
LAN Connection Terminal
Connect the LAN cable (refer to the owner’s manual
of "Network Set-up and Operation").
of "Network Set-up and Operation").
②
③
①
④
⑤
⑨
⑥
⑧
① CONTROL PORT
When the projector is controlled by a computer,
connect to this jack with serial control cable.
connect to this jack with serial control cable.
③
COMPUTER IN / MONITOR OUT
– Connect computer output to this terminal (p.14).
– This terminal can be used to output the incoming
– This terminal can be used to output the incoming
analog RGB and Component signal from
COMPUTER IN 1/COMPONENT IN terminal to the
other monitor (pp.14,16).
COMPUTER IN 1/COMPONENT IN terminal to the
other monitor (pp.14,16).
⑦