Vidikron 30ET ユーザーズマニュアル
40
Vidikron Vision 30 Series Owner’s Operating Manual
PRE
L
IMINAR
Y
Sharpness: “Sharpness” is the amount of high-frequency detail in the image. To adjust
sharpness, select Sharpness from the Picture Adjust menu and press ENTER. On your
external test pattern source, select a pattern like the one shown in Figure 4-5. Adjust as
needed, looking for white edges around the transitions from black to gray and
differently-sized lines in the “sweep” patterns at the top and bottom. Lower the Sharpness
setting to eliminate them.
sharpness, select Sharpness from the Picture Adjust menu and press ENTER. On your
external test pattern source, select a pattern like the one shown in Figure 4-5. Adjust as
needed, looking for white edges around the transitions from black to gray and
differently-sized lines in the “sweep” patterns at the top and bottom. Lower the Sharpness
setting to eliminate them.
Figure 4-5. Typical Test Pattern for Adjusting Sharpness
Color Temp.: The Vision 30 has six memory settings for Color Temperature. Four of these
settings are factory set to default as follows:
settings are factory set to default as follows:
• 0 -- Original lamp color temperature
• 1 -- 5400 kelvins
• 2 -- 6500 kelvins
• 3 -- 8500 kelvins
• 4 -- Custom
• 5 -- Custom
Custom 4 and 5 memory are installer-adjustable and can be used to create custom settings.
There are nine adjustable “white balance” parameters available for the Custom 4 and 5
settings (three each for red, green and blue). These are described later in this section; refer to
Service on page 46.
There are nine adjustable “white balance” parameters available for the Custom 4 and 5
settings (three each for red, green and blue). These are described later in this section; refer to
Service on page 46.
Note