Vidikron VERSION 50 ユーザーズマニュアル
39
Vidikron Vision Model 50 Owner’s Operating Manual
On-Screen Display Menus
Projector Status
Vision Model 50
Picture Adjust
Image Option
Projector Status
Installation
Service
ISF Calibration
Default
Sleep Timer
Lamp Hours
Projector Status
Default
Load
Sleep Timer 30 Minutes
Lamp Power 200 W
Lamp Power 200 W
Lamp Hours
+8 Hours
0 Minutes
To load default settings, configure the sleep timer or adjust the lamp, press MENU, then
press the
press the
▲ or ▼ arrows to highlight Projector Status and press ENTER. The Projector
Status sub-menu will then appear (see above). Press EXIT to return to the previous menu
or press MENU to close all menus.
or press MENU to close all menus.
To restore the default image settings for the current input source ONLY, press the
▲ or ▼
arrow buttons to highlight “Load,” then press ENTER.
The Sleep Timer automatically puts the projector into standby mode after the amount of
time you specify here. (A warning appears on-screen one minute before this is to occur.)
time you specify here. (A warning appears on-screen one minute before this is to occur.)
Press the
◄ or ► arrows to set the timer for anywhere from 10 minutes to 3 hours, in 10-
minute increments. To disable the Sleep Timer, set it to 0.
Select Lamp Power from the Set Up MENU to adjust the lamp output level. You can choose
to run the lamp as bright as possible (250W; this is the default setting) or you can choose
the lower (200W) setting. Generally, lower lamp output can prolong the life of the lamp,
but decreases brightness.
to run the lamp as bright as possible (250W; this is the default setting) or you can choose
the lower (200W) setting. Generally, lower lamp output can prolong the life of the lamp,
but decreases brightness.
Lamp Hours indicates how long the currently-installed lamp has been in service. (This
part of the menu is read-only.)
part of the menu is read-only.)
Lamp Power