Vidikron Vision 110 ユーザーズマニュアル
Vidikron Vision Model 110 Installation/Operation Manual
29
PRE
L
IMINAR
Y
3.7
Connections to the Vision
110
Connections to the Vision
110
Proceed as follows to connect the Vision 110 to your video sources, external controller(s) – if
present – and AC power.
present – and AC power.
When connecting your equipment:
•
Turn off all equipment before making any connections.
•
Use the correct signal cables for each source.
•
Ensure that the cables are securely connected. Tighten the thumbscrews on connectors
that have them.
that have them.
Connector Panel Access
To access the connector panel, press
the door release button so it pops out.
Turn the knob clockwise or
counter-clockwise and pull gently on it
to open the door.
the door release button so it pops out.
Turn the knob clockwise or
counter-clockwise and pull gently on it
to open the door.
Connecting Source
Components to the Vision
110
Components to the Vision
110
Connect your video sources to the Vision 110 as shown and described in the sections that
follow.
follow.
HDMI Connections: See Figure 3-10.
Figure 3-10. HDMI Source Connections
Use the HDMI inputs whenever possible. This ensures the highest video
quality because the signal is carried in the digital domain throughout the
entire signal path, from source component output into the projector.
quality because the signal is carried in the digital domain throughout the
entire signal path, from source component output into the projector.
Tip
HD2 (BNC)
HD1 (RCA)
HD1 (RCA)
HD2 (BNC)
HD3 (VGA / Y-Pb-Pr)
HD3 (VGA / Y
-Pb-Pr)
HDMI or
DVI-to-HDMI Cable
(sold separately)
BD/HD-DVD/
DVD/DTV STB