Vidikron 60 ユーザーズマニュアル

Control Panel on the Projector

��

5
6

1. LAMP BUTTON:

Light On: Indicates the lamp has been used for more than 1900

hours.

Blinking: Indicates the lamp has been used for more than 2000
hours. Please change the lamp.

2. TEMP BUTTON

Blinking: Indicates the temperature inside the projector is

abnormally high.

3. POWER BUTTON

Light On: During projection.

4. STANDBY BUTTON

Light On: In stand by mode.
Blinking: In cool down mode.

5. RGB BUTTON

Use this button to select a device connected to the [RGB1],
[RGB2] or [RGB3] terminals.

6. VIDEO BUTTON

Use this button to select a device such as a video connected to

the [VIDEO IN] terminal ([VIDEO] or [Y/C] Input terminal) of
the projector.

7. POWER BUTTON

When this projector is in standby mode, pressing this button

for more than 1 second will turn the projector on and cause the

[POWER] indicator to light up. Press it one second or more

again, and the projector goes into the cool down mode and finally

into stand by mode.

• The [POWER] button will not work within approximately 1

minute of the light-source lamp being turned on. Hence wait

about 1 minute before pressing.

8. SVC BUTTON

This button is to be used by Vidikron Service Technician.

9. V-KEYSTONE BUTTONS

Use this button to remove the vertical trapezoidal distortion of the

image projected on the screen.

10. H-KEYSTONE BUTTONS

Use this button to remove the horizontal trapezoidal distortion of

the image projected on the screen.

11. MENU BUTTON

Use this button to enter or exit the menu mode. When the main

menu is displayed, pressing this button will cause the menu to
disappear.

12. EXIT BUTTON

Press this button to display the previous menu (For example,

from sub menu to main menu). Pressing this button when the

main menu is displayed will erase the menu.

13. CURSOR BUTTON

These buttons are used in the menu mode to select an item, adjust

the value etc.

14. ENTER BUTTON

Press this button to show the next menu (For example, from main

menu to sub-menu). It is also used when [ENTER] is displayed

against an item on the menu screen, or to choose the “Reset”
option etc.

15. KEY RESET BUTTON

This [RESET] button only works as a reset button for the [SVC],

[V-KEYSTONE] and [H-KEYSTONE] adjustments done on

the control panel and the [SVC], [V-KEYSTONE], and [H-

KEYSTONE] adjustments done on the remote control. When

adjusting the volume, keystone or digital zoom (when the setting

is displayed on the screen) the adjusted value is reset to that

which was set when the projector was shipped from the factory.
This button does not work for the menu (submenu) items.

16. MUTE BUTTON

Use this button to temporarily halt the audio and video output.

Press again to resume.

CONTROLS AND FEATURES