Sharp XG-V10XU ユーザーズマニュアル

A password can be set by the user and used with the
keylock level to prevent adjustments to certain settings
on the GUI.

• When password is set, you need to enter the password to

use “Lamp Mode”, “PRJ Mode”, “Stack Setting”, “Keylock
Level”, “Set Inputs”, “RS-232C” and “Set ID No.” menus.

(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)

1 Press MENU.

2 Press ß/© to select “Options (2)”.

3 Press ∂/ƒ to select “Password”, and then press

©

.

4 Enter the new password using ∂/ƒ to select the

desired number, and then press © to select the
next digit. Continue this procedure for the
remaining three digits, and then press ENTER.

5 Enter the password again (“Reconfirm”) using

∂

/ƒ/ß/©, and then press ENTER.

6 To exit from the GUI, press MENU.

• After setting the password, be sure to write it down in a

secure location in case you can not remember it.

(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)

1 Follow steps 1 to 3 in “Setting the Password”

above.

2 Enter the old password using ∂/ƒ/ß/©, and then

press ENTER.

3 Enter the new password using ∂/ƒ/ß/©, and

then press ENTER.

4 Enter the password again (“Reconfirm”) using

∂

/ƒ/ß/©, and then press ENTER.

1, 6

2, 3
4, 5