Elmo CRP-26 ユーザーズマニュアル

Openings in the cabinet are provided for ventilation. To 

ensure reliable operation of the product and to protect it 

from  overheating,  these  openings  must  not  be  blocked 

or covered. 

 

Hot air is exhausted from the exhaust vent. When using 

or  installing  the  projector,  the  following  precautions 

should be taken. 

– Do not put any flammable object or spray can near the 

projector, hot air is exhausted from the air vents.

– Keep the exhaust vent at least 3’ (1 m) away from any 

objects.

–  Do  not  touch  a  peripheral  part  of  the  exhaust  vent, 

especially screws and metallic parts. These areas will 

become hot while the projector is being used.

–  Do not put anything on the cabinet. Objects put on the 

cabinet will not only get damaged but also may cause 

fire hazard by heat.

Cooling  fans  are  provided  to  cool  down  the  projector. 

The  fans’  running  speed  is  changed  according  to  the 

temperature inside the projector.

When moving the projector, replace the lens cap and 

retract adjustable foot to prevent damage to the lens and 

cabinet.

When the projector is not in use for an extended period, 

put it into a suitable case.

Air Intake Vent

Exhaust Vent

(Hot air exhaust)

Air Intake Vent

Do not tilt the projector more than 30 

degrees from above and below.

Do not point the projector up to project an 

image.

Do not point the projector down to project 

an image. 

Do not put the projector on either side to 

project an image. 

Install  the  projector  properly.  Improper  Installation  may 

reduce the lamp life and cause a fire hazard.

Do not tilt the projector more than 20 

degrees from side to side.

20°

20°

30°

30°

 

 

– Do not drop or bump the projector, otherwise damages  

or malfunctions may result.

–  When carrying the projector, use a suitable carrying case.

– Do not transport the projector by courier or any other 

transport service in an unsuitable transport case. This 

may cause damage to the projector. For information 

about transporting the projector by courier or any other    

transport service, consult your dealer.

– Do not put the projector in a case before the projector is 

cooled enough.