Epson EB-Z8000WU ユーザーズマニュアル

ページ / 107
Refer  to  the  following  table  to  see  what  the  indicators  mean  and  how  to  remedy  problems  that  they  indicate.
If  all  indicators  are  off,  check  that  the  power  cable  is  connected  correctly  and  that  the  power  is  being  supplied  normally.
Sometimes,  when  the  power  cable  is  unplugged,  the  
t
 indicator  remains  lit  for  a  short  period,  but  this  is  not  a  fault.
t
 Indicator  is  lit  or  flashing  red
:   Lit  
:   Flashing:  
:   Off
Status
Cause
Remedy or Status
Internal Error
Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest
address provided in the Support and Service Guide. s 
Fan Error
Sensor Error
Cool System Error
Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest
address provided in the Support and Service Guide.s 
High Temp Error
(overheating)
The lamp turns off automatically and projection stops. Wait for about five minutes. After about five minutes the projector
switches to standby mode, so check the following two points.
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it. s 
If the error continues after checking the points above, stop using the projector, disconnect the power cable from the
electrical outlet, and contact your local dealer or the nearest address provided in the Support and Service Guide.
s
 
When using at an altitude of 1500 m or more, set High Altitude Mode to On. s 
Set Direction to Pointing Down or Pointing Up when the projector is installed to project images downward or upward.
s
 
Lamp Error
Lamp Failure
Check the following two points.
• Take out the both lamps and check if they are cracked. s 
• Clean the air filter. s 
If it is not cracked
: Re-fit the lamp and turn on the power.
If the error continues
: Replace the lamp with a new lamp and turn on the power.
If the error continues
: Stop using the projector, disconnect the power cable from the electrical outlet, and contact your
local dealer or the nearest address provided in the Support and Service Guide. s 
Problem Solving
56