Infocus SP-CEIL-003 プリント

 

q 

Install the two (2) conical spacers (J) and two (2) flat washers (K) two 
(2) hinge pin screws (L) loosely on both sides of the base box (H). 
Raise the projector with the mounting bracket attached and slip though 
the hinge pin slots openings on the bracket into the base box. Install the 
two (2) angle locking screws (I) adjust the angle, lock it, and then 
tighten the hinge pin screws (L). 
See Figure 3 

 

  

 
  
 
 
 
 
 

 
 
  
 
 
 
 
 

 
 
 
 
 
 
 
 
 

Check all hardware for proper tighten and security. 

 

 

 

 

 
 
 

 
 
 
 
 

 

The ceiling should be capable of supporting a weight of 

at least five (5) times the weight of 45 Lbs. If it cannot, the 

ceiling must be reinforced. Proper installation procedure 

by qualified personnel as outlined in the installation 

instructions must be adhered to. Failure to do so could 

result in serious personal injury. 

 
 

 

A. 8 (mm) x 10 (mm) Phillip Screws (6ea)  
B. SP-CEIL-003 Mounting Bracket (1ea)  
C. Projector (Not Supplied)  
D. Projector’s Feet  
E. Projector Lens 
F. Suitable Hardware (Commercially Available)  
G. Ceiling Structure (See Warning Label) 
H. Base Box/Jam Nut (1ea) 
I.  6 (mm) x 12 (mm) Angle Locking Screws (2ea)  
J.  Conical Spacers (2ea) 
K. Flat Washers (2ea) 
L. 6 (mm) x 12 (mm) Hinge Pin Screws (2ea) 

         M. 

SP-LTMT-EXT Adjustable Suspension Adapter   

         N. Suspension Adapter Adjustable Pins (2ea)

  

 

          

 

 
 
 
 
 

 
 
 
 
 
 
 
 
 

 
 

 
 
 
 
 

 
 
 
 
 
 
 
 

 

 

                                                 
                   
                           
                                                    
 
 

 
 
 
 
 
 
 

 

 

 

      
 

            27700B S.W. Parkway Ave. 

         Wilsonville, Oregon 97070-9215 

       Phone 1-800-294-6400  Fax

 

       

www.infocus.com

 

For further information or ordering assistance 

contact us at the phone/address number shown 

on the front of this page.