Infocus SP-CEIL-001 プリント

 

 

 

Invert the projector and place it on a soft and flat surface. 
Locate the three (3) 4 (mm) mounting points found on the 
bottom of the projector (C). Secure the two (2) Quick release 
sleeves (B) with the two (2) 4 (mm) x 20 (mm) Phillip Screws (A)  
(supplied). Align the keyhole openings from the mounting 
bracket (E) to the sleeves (B) and secure the bracket with the  
4 (mm) x 16 (mm) knurl knob (D) (supplied). 
Do not over tighten! 
See Figure 1  

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 

 

Install the base box securely to the ceiling structure in  
accordance with proper commercial standards. Use 
(commercially available) suitable hardware depending on the 
installation requirements.  

 

 

NOTE: 

If the (Optional) SP-LTMT-EXT Adjustable height 

suspension adapter is a part of the installation, securely install 

the ceiling adapter to the ceiling at this time.

 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 
 

 

Install the two (2) conical spacers (K) and two (2) flat washers (J) two 
(2) hinge pin screws (I) loosely on both sides of the base box (L). Raise 
the projector with the mounting bracket attached and slip though the 
hinge pin slots openings on the bracket into the base box. Install the 
two (2) angle locking screws (H) adjust the angle, lock it, and then 
tighten the hinge pin screws (I). 
See Figure 2 

 
 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

 

Check all the hardware for proper tightness and security. Do not 
over tighten hardware.