Infocus IN3118HD ユーザーズマニュアル
IN3118HD User’s Manual
– 38 –
LED Error Messages
E
RROR
C
ODE
M
ESSAGES
P
OWER
LED
L
AMP
/
R
EADY
LED
T
EMP
LED
Powered on
Solid Green
Solid Red
OFF
Powering up
Solid Green
Flashing Red
OFF
Cooling down
Solid Green
Flashing Red
OFF
Over Temperature
OFF
OFF
Solid Red
Thermal Break Sensor error
Flashes Green 4x
Flashes Green 4x
OFF
Lamp error/Color wheel control error
Flashes Green 5x
OFF
OFF
Lamp End of lamp life detected
Flashes Green 5x
Flashes Green 3x
OFF
Burner Fan error
Flashes Green 6x
Flashes Green 1x
OFF
Lamp Fan error
Flashes Green 6x
Flashes Green 2x
OFF
Power Fan error
Flashes Green 6x
Flashes Green 3x
OFF
DMD Fan error
Flashes Green 6x
Flashes Green 4x
OFF
Case Open
Flashes Green 7x
OFF
OFF
DMD error/Ignition failed
Flashes Green 8x
OFF
OFF
Color wheel error
Flashes Green 9x
OFF
OFF
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before re-
starting the projector. If the POWER or LAMP LEDs are still blinking or the TEMP LED is lit, contact
InFocus Technical Support at
starting the projector. If the POWER or LAMP LEDs are still blinking or the TEMP LED is lit, contact
InFocus Technical Support at
Image Problems
Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
3. Many laptops do not automatically turn on their external video port when a projector is
connected. Usually a key combination like FN + F8 or CRT/LCD key turns the external
display on and off. Locate a function key labeled CRT/LCD or function key with a monitor
symbol. Press FN and the labeled function key simultaneously.
display on and off. Locate a function key labeled CRT/LCD or function key with a monitor
symbol. Press FN and the labeled function key simultaneously.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Press the Auto Image button on the remote control or the Re-sync button on the keypad.
3. Ensure the projector-to-screen distance is within the 10-meter (33-feet) specified range.
4. Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
1. Position the projector so it is as perpendicular to the screen as possible.
2. Use the Keystone button on the remote control or projector to correct the problem.
Problem: The image is reversed
Check the Projection setting on the Setup >> Basic menu of the OSD.