Infocus IN3128HD ユーザーズマニュアル
41
1
Turn off the projector and unplug the power cord.
2
Wait 60 minutes to allow the projector to cool thoroughly.
3
Remove the lamp door, located on top of the projector, by removing the screws
on either side of the lamp door, sliding the door forward, and lifting the lamp
door off.
on either side of the lamp door, sliding the door forward, and lifting the lamp
door off.
4
Loosen the captive screws that attach the lamp housing to the projector.
NOTE: If the projector is installed on a ceiling mount, be careful not to drop the
lamp module once the captive screws are loosened.
lamp module once the captive screws are loosened.
5
Carefully lift the lamp straight up, off of the alignment pins; being careful not to
pinch the lamp connector. Dispose of the lamp in an environmentally proper
manner.
pinch the lamp connector. Dispose of the lamp in an environmentally proper
manner.
6
Install the new lamp module, aligning the pins properly. Be careful not to pinch
the lamp connector.
the lamp connector.
7
Tighten the screws. (NOTE: If the pins have not been aligned properly, the
screws will not tighten securely.)
screws will not tighten securely.)
8
Replace the lamp door by (a) aligning the door (b) sliding it towards the back
and (c) locking it back into place.
and (c) locking it back into place.
9
Replace the lamp door screws and tighten securely.
10
Plug in the power cord and press the Power button to turn the projector back on.
11
To reset the lamp hour timer, navigate to the Advanced Menu > Status/Service
menu and select Reset Lamp Hours....
menu and select Reset Lamp Hours....
turn off and unplug
projector
projector
wait 60 minutes
loosen screws
loosen lamp door screws
Image
Setup
Status/Service
Basic Menu
Source Info
Projector Info
Reset Lamp Hours
Factory Reset
Service Code
(
Advanced Menu
)
MDL: IN3128HD
FW: 0.10