Infocus LP 740TM ユーザーズマニュアル

•

Do not look directly into the projection lens when the projector 
is turned on. The bright light may harm your eyes.

•

Do not block the grills on the projector. Restricting the air flow 
can cause it to overheat and turn off. If this happens, you must 
wait a minute before attempting to turn it back on.

•

Handle the projector as you would any product with glass 
components. Be especially careful not to drop it.

•

Avoid leaving the projector in direct sunlight or extreme cold 
for extended periods of time. If this happens, allow it to reach 
room temperature before use.

•

This projector is not intended for use in a mainframe computer 
room as defined in the Standard for the Protection of Electronic 
Computer/Data Processing Equipment, ANSI/NFPA 75.

•

Transport the projector in a vendor-approved hard or soft case. 
Part numbers for these cases are listed on page 34. Call your In 
Focus dealer to order.

The first place to look for help is in this manual. Be sure to check 
the guidelines in “Troubleshooting” on page 29. 

If this manual doesn’t answer your question, call your In Focus 
dealer. You can also call In Focus Customer Service directly at

. Call between 5 a.m. and 5 p.m. PST, Monday 

through Friday. In Europe, call In Focus in The Netherlands at 

. In Singapore, call 

. Or, send us an 

e-mail at 

Our World Wide Web address is

 http://www.infocus.com.

This product is backed by a limited one-year warranty. The 
details of the warranty are printed at the back of this manual. 
Longer term warranties can be purchased from your In Focus 
dealer. Refer to page 34 for part numbers.