Infocus IN5134 ユーザーズマニュアル

ページ / 33
20
STACK menu settings
(continued on next page)
3.7 Important information for Intelligent Stack 
This section provides important information related to setting up the Main and Sub 
projectors. It does not contain explanations on menu operation. Read all information 
carefully.
● To use Intelligent Stack, one projector must be set to Main and the other set to 
Sub.
● All buttons are disabled, except the 
STANDBY/ON button on the Sub projector's 
control panel. Operate the projectors with the control panel of the Main projector 
or the remote control.
● Pressing the 
STANDBY/ON button of the Sub projector does not allow you to 
turn off the Sub projector by itself. The Main and Sub projectors turn off when 
the button is pressed for more than 3 seconds. Pressing the button again will 
not turn on the Main or Sub projector.
● The remote control should be pointed at the Main projector because the Main 
projector is capable of receiving remote control signals and the Sub projector is 
not.
● <Only for 
IN5142IN5144, IN5144a and IN5145
Each Status Monitor can also be operated individually from the respective 
control panel of the Main and Sub projectors. Only the monitor on the projector 
that has been turned on can be operated with the remote control.
● If a wired remote control is used, connect the cable to the Main projector instead 
of the Sub projector.
● For simple PC mouse & keyboard functions, connect both the Main and Sub 
projectors to your computer with USB cables. (
Operating Guide
 → 
Using as a 
simple PC mouse & keyboard
)
● The AUTO SEARCH function is disabled when the projector is used in Intelligent 
Stack.
● The Sub projector cannot be turned on using network communication and Web 
Control to the Sub projector. The Sub projector can only be controlled through 
the Main projector.
● The Web Remote Control function of the Sub projector is disabled. (
Network 
Guide
 → 
3.1.11 Remote Control
)
● If you try to turn on the projectors using the POWER ON & DISPLAY ON feature 
of the MESSENGER function, the projectors will exit Intelligent Stack and 
display the specified message. To start Intelligent Stack again, re-select MAIN/