Infocus IN5504 ユーザーズマニュアル

Shutting down the projector

Screen Save Time

You can make the black screen appear after a preset number of minutes by

turning on the Screen Save Time feature in the Setup menu. See page 30.

Auto Off Time

The projector has an Auto Off Time feature that automatically turns the

projector off if no active sources are detected and no user interaction with

the projector is performed for 30 minutes. By default, this feature is off. You

can change the length of time, see page 30.

Turning off the projector

To turn the projector off, press the Power button on the remote or keypad.

The lamp turns off, a beep sounds and the LED blinks amber for 10 seconds

while the fans continue to run to cool the lamp. When the lamp has cooled,

the LED lights amber and the fans stop. Unplug the power cable to

completely power off the projector.

Troubleshooting your setup

The Status Indicator Panel on top of the projector indicates the state of the

projector and is helpful when troubleshooting.

Table 1: Status indicator light behavior and meaning

Icon

Meaning

Power, solid amber

Power, blinking green

Power, solid green

Power, blinking amber

The projector is plugged in.

The power button has been pressed and the software is
initializing.

The projector is on and initialized.

The power button has been pressed to turn the projector
off and the fans are running to cool the projector.

Temperature

The projector is too hot. Make sure the vents aren’t blocked

(see page 21). Turn the projector off and wait one minute,

then turn the projector on again. Contact Technical Support

if the problem persists. Visit www.infocus.com/support to

contact service.

Lamp

Turn the projector off and wait one minute, then turn the

projector on again. If the lamp light turns on again, replace

the lamp and reset the lamp timer

Note: For dual-lamp projectors, one blink off every 2

seconds means the problem is with lamp #1; two blinks off

every 2 seconds means the problem is with lamp #2.

Wrench/Service

Turn the projector off and wait one minute, then turn the

projector on again. If the service lamp turns on again, service

is required. Visit www.infocus.com/support to contact

service.