Infocus LP1200 ユーザーズマニュアル

11

Screen on a flat wall with a 90 degree angle to the floor
by adjusting two foot adjustments on the bottom of the
projector.  If the angle cannot be corrected by them,
adjust the height and angle of screen.

1. Lift the projector to the right angle.

2. Press the release button for angle adjustment to take

the adjustment feet out of the projector.

3. Release the button and keep your hands away from

the projector.

4. Turn the both feet to right or left to adjust for proper

angle.

After using the projector
5. Press the release button to take the projector down

slowly while holding it.

Important:
The image becomes trapezoid shape when the screen
or projector is not level.  Use KEYSTONE in INSTAL-
LATION menu to adjust, however, the circumference
of the image may not be focused. See page 20.

• Screen on a flat wall with a 90˚ angle to the floor.
• Align projector to produce a full screen display as

illustrated on page 10.

• Distance from projector to screen must be

compatible with screen size chart on page 10. Note
distance from screen chart.

• If image is not square on screen, try adjusting the

front feet of the projector for proper angle.

1. Connect the power cord provided to this projector

with the power jack of the projector.

2. Connect the power cord to the wall outlet.

3. Take off the lens cap.

4. Do not look directly into the lens when projector is

“ON”.

Warning:
• The lens cap is for protecting the lens.  If you leave the

power on with the cap on, the cap may be warped.  Please
remove the lens cap when you turn the power on.

• Use the appropriate power cord for your country.
• A three-pin grounding type power plug is used with

the projector. Do not remove the grounding pin on
the power plug. If you are unable to insert the plug
into the outlet, contact your electrician to replace
your obsolete outlet.

• Use 100-240V AC 50/60Hz correct voltage

otherwise it may lead to fire or electric shock.

• Do not place an object on the power cord and keep

the projector away from heat source to avoid break-
ing the power cord. A broken of power cord can cause
fire or electric shock.

• Do not revise or alter the power cord otherwise it

may cause fire or electric  shock.
Contact your dealer if the cord is broken.

Caution:
• Plug in firmly and unplug by holding the plug, not

by pulling the cable out.

• Do not plug in or out  with wet hands.  It may cause

an electric shock.