Infocus IN3916 ユーザーズマニュアル

You can make the black screen appear after a preset number of minutes by turning 
on the Screen Save Time feature in the Setup menu. See page 33.

The projector also has an Auto Off Time feature that automatically turns the 
projector off after no active sources are detected and no user interaction with the 
projector is performed for 30 minutes. By default, this feature is off. You can 
change the length of time, see page 33.

To turn the projector off, press the Power button on the remote or keypad. The lamp 
turns off and the LED blinks amber for 1 minute while the fans continue to run to 
cool the lamp. When the lamp has cooled, the LED lights amber and the fans stop. 
Unplug the power cable to completely power off the projector.

If your image appears correctly on the screen, skip to the next section. If it does not, 
troubleshoot the setup.

The Status Indicator Panel on top of the projector indicates the state of the projector 
and can help you troubleshoot.

Power, solid amber

Power, blinking green

Power, solid green

Power, blinking amber

The projector is plugged in.

The power button has been pressed and the 
software is initializing.

The projector is on and initialized.

The power button has been pressed to turn 
the projector off and the fans are running 
to cool the projector.

Thermometer

The projector is too hot. Make sure the 
vents aren’t blocked (see page 22). Turn 
off the projector and wait one minute, then 
turn the projector on again. Contact 
Technical Support if the problem persists. 
Visit www.infocus.com/support to contact 
service.

Lamp

Turn off the projector and wait one minute, 
then turn the projector on again. If the 
lamp light turns on again, replace the lamp 
and reset the lamp timer. 

Wrench/Service

Turn off the projector and wait one minute, 
then turn the projector on again. If the 
service lamp turns on again, service is 
required. Visit www.infocus.com/support 
to contact service.