Infocus IN5532 ユーザーズマニュアル

Custom commands you enter here should be in write format (do not

include '?'), and should use '<' and '>' instead of '(' and ')'. Example: to turn

on the ceiling mount setting, use the custom command <CEL1>.

User Access and Security Page (administrators only)

This page lets you configure security options for the projector, including log

in passwords and projector access restrictions.
Web Access - Administrator tab:

Select whether or not Administrators must

enter a password to log into the projector's web pages. If a password is

required, click create or change password to update the administrator

password.
Web Access - Basic User tab:

Select whether or not Basic Users must enter a

password to log into the projector's web pages. If a password is required,

click create or change password to update the basic user password.
Projector PIN tab:

Allows you to turn projector PIN protection on or off, or

change the PIN. When PIN protection is on, the current PIN must be

entered when the projector is powered on, otherwise the projector will not

operate. NOTE: PIN protection only applies to projector operation via the

projector's keypad and remote control; it does not affect the projector's web

pages.

System Log Page (administrators only)

This page shows a log of the 100 most recent projector events.
Erase Log…:

Click this to erase all events in the log.

Network Utilities Page (administrators only)

This page lets you perform various network-related projector tasks.
Save and Load Projector Configuration:

These functions save and load all

network-related projector settings into/from a file stored on your

computer. This lets you quickly 'clone' network settings from one projector

to other projectors.
Upgrade Projector Network Firmware:

Upgrades the firmware for the

projector's network and LitePort features (this firmware is separate from the

regular projector firmware).
Restart Projector Network Subsystem:

Restarts the projector network

subsystem; does not change any projector settings.

Network Subsystem Factory Reset:

Returns all network and LitePort settings

to default values and then restarts the projector network subsystem.

Troubleshooting Network Functions

•

If network status is shown as Not Connected in the projector's Network

menu, or the projector does not display its IP address, check the cable

or the network configuration.

•

If your web browser displays Page Not Found or a similar error when

you try to access the projector's web pages, verify that the

projector is connected to the network (select the Network item in the

projector's Setup menu and verify that Network Status shows as

Connected); if there is no connection refer to the troubleshooting item

above for more help.

•

Make sure the Network item in the Always-On Functions submenu in

the Setup menu is set to Yes (if it is set to No, the projector web pages

will only be available when the projector is powered on).

•

If scheduled tasks are not performed, check if the SNTP is set up

correctly and is online. Also check if the Command sequence is correct.

•

If automatic emails are not sent, check if SMTP is set up correctly and is

online.

To manually restart the projector network subsystem:

Use the projector's

remote control or keypad to select the Network item in the projector's Setup

menu. Then scroll down and select either Restart Network (to restart the

network subsystem without changing any settings), or Network Factory

Reset (to return all network settings back to default values, and then restart

the network subsystem). If the manual restart procedure does not work: To

force the network subsystem to restart, disconnect the projector from AC

power, wait 10 seconds, then reconnect AC power.