HP (Hewlett-Packard) sb21 ユーザーズマニュアル
12
Connecting the hp digital projector sb21 to a
computer
computer
Connect the power cord to the
projector and a power outlet.
projector and a power outlet.
Connect the black end of the
video cable to the projector.
video cable to the projector.
Connect the blue end of the
video cable to the PC; optionally,
to have the remote control
function as a mouse, connect the
USB connector to the PC.
video cable to the PC; optionally,
to have the remote control
function as a mouse, connect the
USB connector to the PC.
Start the projector; after a 30-
second warm-up it will search for
a video signal.
second warm-up it will search for
a video signal.
If no video signal is found, you
may need to set up the PC to
send a video signal out the video
port.
may need to set up the PC to
send a video signal out the video
port.
installation
CAUTION!
Unplugging the projector while
the fan is running may reduce
lamp life.
Unplugging the projector while
the fan is running may reduce
lamp life.
NOTE: For best performance,
configure the display
mode of your computer’s
graphic card to 800×600
resolution. Ensure the
timing of the display
mode is compatible with
the projector. Refer to the
“hp sb21 compatibility
modes” section on
page 37.
mode of your computer’s
graphic card to 800×600
resolution. Ensure the
timing of the display
mode is compatible with
the projector. Refer to the
“hp sb21 compatibility
modes” section on
page 37.
sb21