Infocus LP 420TM ユーザーズマニュアル

 Do

 

not look directly into the projection lens when the projector is 

turned on. The bright light may harm your eyes.

D

o not block the grills on the projector. Restricting the air flow can 

cause it to overheat and turn off. If this happens, you must wait a minute 
before attempting to turn it back on.

Handle the projector as you would any product with glass compo-

nents. Be especially careful not to drop it.

Avoid leaving the projector in direct sunlight or extreme cold for 

extended periods of time. If this happens, allow it to reach room temper-
ature before use.

This projector is not intended for use in mainframe computer 

rooms as defined in the Standard for the Protection of Electronic Com-
puter/Data Processing Equipment, ANSI/NFPA 75.

Transport the projector in a vendor-approved hard or soft case. 

Part numbers for these cases are listed on page 35. 

connector panel

speaker

focus ring

elevator button

power
cord
connector

keypad