Boxlight CD-550m ユーザーズマニュアル
8
S
e
t
t
i
n
g
u
p
t
h
e
P
r
o
j
e
c
t
o
r
Connecting the CablePro III to the Projector
CAUTION: Turn off the
computer, monitor and projector
whenever you connect or
disconnect cables.
The CablePro III (referred to as “CablePro” in this manual for
brevity) simplifies the connection process by providing a central
hub for all the connections between the projector and your com-
puter. The connectors on the CablePro are labeled with icons. The
CablePro also has an LED that lights solid green when the projec-
tor is on and CablePro is functioning properly. A slowly blinking
LED indicates CablePro is waiting to initialize with the projector;
a rapidly blinking LED indicates a problem with CablePro.
brevity) simplifies the connection process by providing a central
hub for all the connections between the projector and your com-
puter. The connectors on the CablePro are labeled with icons. The
CablePro also has an LED that lights solid green when the projec-
tor is on and CablePro is functioning properly. A slowly blinking
LED indicates CablePro is waiting to initialize with the projector;
a rapidly blinking LED indicates a problem with CablePro.
Connect the
end of the CablePro cable to the
connector on the projector’s connector panel (Figure 5).
NOTE: The projectors are
optimized for use with newer
CablePros (2 and 3). If you have a
CablePro 1from older models of
Boxlight projectors, we do not
recommend using it as image
quality is reduced. The label on the
bottom reads CablePro or
CablePro II or CablePro III.
F
IGURE
5
Connecting the CablePro to the projector
NOTE: In some older computers,
the monitor connector does not
have a hole for Pin 9. If you have
trouble connecting the CablePro to
your computer, contact Boxlight.