Xerox 8850 ユーザーズマニュアル

Margins are added to the image in one of two ways: 

• 

If Synchro has been selected from the Output Format area of 
the Scanner Control Panel, the lead margin is added before the 
image is printed.  The trail margin is added after the media cut 
signal is received from the Scanner.  Thus, the length of the 
media from the Printer will be the scanned document length plus 
the lead and trail margins. 

• 

If a fixed media length (Preset or Manual) has been selected as 
the Output Format, the white space of the specified margin 
surrounds the image, but the actual physical dimensions of the 
media remain as specified.  The margins reduce the allowable 
area on the media in which the image may be placed. 

To adjust the margins for an image: 

1.  Press the Transform key.  The TRANSFORM MENU screen is 

displayed. 

2.  Press the Enter key to select MARGINS.  A screen displaying 

the settings for each margin is displayed.  Below is an example 
of the screen. 

LEAD

+ 1.0 IN

LEFT

+ 0.0 IN

RIGHT

+ 0.0 IN

TRAIL

+ 0.0 IN

 

If the unit of measure has been set to inches, "IN" appears next to each 
value.  If the unit of measure has been set to millimeters, "MM" appears 
next to each value.  Refer to "Localization" in the "Main 
CONFIGURATION " section for information about setting the display 
units. 

The graphical display to the right of the margin settings illustrates the 
approximate placement of the image as a result of the settings. 

3.  Press the Previous or Next key to highlight the setting you wish 

to change. 

4.  Press the Enter key to select the setting. 

5.  Change the setting as follows: 

• 

To change the "+" or "-" setting, press the Previous or Next key. 
n edge of the image can be clipped by entering a negative 
margin value for that edge.  In that case, the affected edge is 
shown as a dotted line and the image icon is shown as partially 
outside the bounds of the media.