Manualsbrain.com
  1. マニュアル
  2. ブランド
  3. Panasonic
  4. SV-P10U
  5. ユーザーズマニュアル

Panasonic SV-P10U ユーザーズマニュアル

ダウンロード
ページ / 28
8
1
1
DC IN
4.9V
2
1
2
2
1
2
DC IN
4.9V
Power Supply
ª
Using AC Adaptor
1
Connect the DC Input Lead to the [DC IN 4.9V] socket on 
the SD Mobile Printer.
2
Connect the AC Main Lead to the AC Adaptor and the AC 
outlet.
≥Hold down the Power Button [ 
 ] for about 2 seconds, and the 
printer is turned on.
ª
Using the Battery
1
Attach the Battery 
1 
to the Battery Holder on the SD 
Mobile Printer and slide it forward until it locks with a 
click.
2
Connect the AC Main Lead to the AC Adaptor and to an 
AC Outlet. (Refer to the description above.)
≥The [
 
 
] Lamp flashes.
3
Leave them as above until the Power Lamp [ 
 
] goes 
off.
≥When recharging is completed, the [
 
 
] Lamp goes OFF.
≥Remove the AC Adaptor to use the Battery.
Ejecting the Battery 
Press and hold 
1 
the claw 
2
 toward the direction shown by the 
arrow and slide the battery to eject 
2
.
≥It takes about 100 minutes, maximum for full-charging. (at a 
temperature of 20°C and humidity 60%) If the Battery is charged at a 
higher or lower temperature, the charging time may be longer.
≥When recharging, turn the power of the printer OFF.
≥If the [ERROR] Lamp lights or flashes during recharging, recharging is 
not normal. Refer to “Error Lamp” on page 22.
≥Remove the battery if the printer is left unused for a long time.
≥Full charge of the battery enables you to print near up to 45 sheets 
continuously at ambient temperature.
The SOCKET OUTLET SHALL BE INSTALLED NEAR THE 
EQUIPMENT AND SHALL BE EASILY ACCESSIBLE
.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by 
the manufacturer.
Dispose of used batteries according to the manufacturer’s 
instructions.
Using AC Adaptor
Using the Battery
SDP1U.book  8 ページ  ２００２年１月２８日 月曜日 午後７時４８分